Posts

Showing posts from October, 2026

Anti-acid EVA vs low-acid EVA vs EPE: what module makers should choose

Image
For years, standard EVA was good enough for most solar modules. Then TOPCon arrived, and the rules changed. Researchers at UNSW found that EVA-encapsulated TOPCon modules lost output under damp heat mainly because of acetic acid from the EVA, which corroded the cell contacts (pv magazine). Suppliers have answered with three main options: low-acid EVA, anti acid EVA encapsulant , and EPE. Each one claims to solve the acid problem. But they work in very different ways, and they don’t cost the same. At Raynex Solar, we manufacture both EVA and EPE encapsulant , and module makers ask us this question every week. Most of what you will find online comes from launch news and supplier promotions. This guide takes a neutral, test-based view instead. We explain how each option controls acid, where each one falls short, and how to check a supplier’s claims. Then we give you a simple guide to choose the right one for your cell type, module build, and climate. Why Acetic Acid Is a Problem in EVA En...

What Is PID in Solar Panels? Causes, Effects and Prevention

Image
What if a solar plant looked perfect on day one, then quietly lost a fifth of its output within two years? That is what PID in solar panels can do. PID stands for potential induced degradation , and it is one of the most costly faults in modern solar modules. A survey by PI Berlin found PID in 20 solar plants in Germany. In one 10.7 MW plant in Spain, it hit 41% of the modules (PV Tech). The hard part is that PID is often invisible to the eye. At Raynex Solar, we make the layer that sits right where PID starts: the solar encapsulant . So we look at this problem from inside the module. In this guide, we explain what PID is, why it happens, and how much yield it can cost. We also cover how to spot it, how it is tested, and which encapsulant gives the best defense. By the end, you will know exactly what to specify to keep PID out of your modules. What Is PID in Solar Panels? PID in solar panels is a loss of output caused by a large voltage gap between the solar cells and the grounded fra...

EPE Encapsulant in Solar Panels: Structure, Properties and Benefits

Image
Five years ago, few module makers had even heard of EPE. Today, it is close to becoming the most used solar panel encapsulant on the market. EPE encapsulant grew from a 5% market share in 2019 to 38% in 2024, while EVA held 42% (pv magazine). That is a fast shift for a material most buyers never see. It sits inside the module, wrapped around every cell. Yet it shapes how long a module lasts and how much energy it makes. At Raynex Solar, we manufacture EPE alongside EVA and POE, so we see where each one fits and where each one falls short. In this guide, we explain what EPE encapsulant is and how its three layers work. We also cover its key properties, typical specs, and the modules it suits best. Unlike most supplier articles, we also name the limits you should check before you buy. By the end, you will know if EPE is the right choice for your next production run. Role of Solar Encapsulants in Solar Panels Before we look at EPE, it helps to know what any encapsulant does. A solar mod...